from Tumblr http://ift.tt/1gcIrJp
via IFTTT
Originally published at The Scotto Grotto. You can comment here or there.
from Tumblr http://ift.tt/1gcIrJp
via IFTTT
Originally published at The Scotto Grotto. You can comment here or there.
Police taping off a building that they just stormed on M St. across from the Dept. of Transportation. (via pjelliot on twitter)
from Tumblr http://ift.tt/1Nz8Prx
via IFTTT
Originally published at The Scotto Grotto. You can comment here or there.
Second scene near 3rd and M near #navyyard
from Tumblr http://ift.tt/1Nz8S6J
via IFTTT
Originally published at The Scotto Grotto. You can comment here or there.
4th’ and M locked down, 3rd and m police cruisers all over the place.
WASHINGTON (WUSA9) – U.S. Park Police and Metropolitan Police Department officers are responding to Navy Yard for a report of active shooter. No casualties at this time.
An employee inside Navy Yard reports that alarms are sounding and the buildings are on lockdown.
We are waiting for more details.
from Tumblr http://ift.tt/1GQxgvD
via IFTTT
Originally published at The Scotto Grotto. You can comment here or there.
hodge-podge misc folder, mostly newton and me at the old place in pompano – no-nose’s joint.
Originally published at The Scotto Grotto. You can comment here or there.
https://en.wikipedia.org/wiki/You_aren’t_gonna_need_it
“You aren’t gonna need it“ (acronym: YAGNI) is a principle of extreme programming (XP) that states a programmer should not add functionality until deemed necessary. XP co-founder Ron Jeffries has written: “Always implement things when you actually need them, never when you just foresee that you need them.”[ Other forms of the phrase include “You aren’t going to need it” and “You ain’t gonna need it”.
Originally published at The Scotto Grotto. You can comment here or there.
At the command prompt type
sudo nano /etc/wpa_supplicant/wpa_supplicant.conf
This will load a basic text editor with the wifi configuration file.
You will just need to add a new “section” to the file for your network or modify an existing one.
e.g. Say that your SSID is “salmagundi” and it uses WPA2 security with a wifi password of “n0beef” you would add the following lines
network ={
ssid=”salmagundi”
psk=”n0beef”
key_mgmt=WPA-PSK
proto=RSN
pairwise=CCMP TKIP
group=CCMP TKIP
auth_alg=OPEN
}
To save this press <Ctrl> X then press Y and finally press <ENTER>.
At this point if you reboot your device it should then connect to your WiFi.
type
sudo reboot
Now remove the Ethernet Cable.
During boot up you should see the WiFi dongle’s activity light start blinking (rapidly) to indicate it has established a connection to your wifi.
see also – https://learn.adafruit.com/adafruits-raspberry-pi-lesson-3-network-setup/finding-your-pis-ip-address
Originally published at The Scotto Grotto. You can comment here or there.